Levolor Cellular Shade Series - Page 7

5
INSTALLATION
INSTALLATION
■
Attach the installation or extension brackets using the screws provided.
IMPORTANT: The front edges of the brackets must be level and aligned to
each other.
■
If using spacer blocks, first attach the installation bracket to the
1
⁄ 2 " spacer
block before stacking additional spacer blocks together.
➤
Insert the legs of the installation bracket into the tabs on the spacer block.
➤
Then rotate the installation bracket back.
■
Attach the spacer block and installation bracket to a flat vertical
mounting surface with a #6 mounting screw long enough for
asecure installation.
➤
A maximum of 1
1
⁄ 2 " of spacer blocks per installation bracket is
recommended.
➤
The top of the spacer blocks should be at the desired shade
height.
IMPORTANT: The front edges of the installation brackets must be
level and aligned to each other.
CAUTION: Use drywall anchors when mounting into drywall.
■
If using extension brackets, attach an installation bracket to the
underside of each extension bracket using theprovided screws and
speed nuts.
Proceed to "Install the Shade" on page 6 .
Tab
Longer Screw
(Not Provided)
Maximum
1
1
∕ 2 "