Capstan Gypsy/Capstan model - To use the capstan (with rope
Operation only) lock the gypsy off with the brake band or pawl to
stop the chain from free running. Place a Lewmar winch
handle into the top nut and raise the capstan until the
dog drive is fully disengaged.
Press the Up button to power the Capstan.
Dog Drive Place a Lewmar winch handle into the top nut and lower
Engagement the capstan down onto the gypsy until resistance is felt,
then backwind one quarter of a turn.
Press the Up/Down switch and the dog drive will spring
down into positive engagement. Tighten down the top nut
securely if required.
Once the dog drive has been fully engaged, stop power
operation and release the brake band or gypsy pawl
before powered operation is continued.
Warning!
Ensure that the dog drive is fully engaged
when powering in or out.
Keep hands and feet clear of free running chain.
Do not leave a winch handle in the windlass while
operating.
Classification society rules require that a vessel lying at
anchor should have its chain held by a cable/chain
stopper or equivalent strong point as a windlass should
not be subjected to the loads generated under storm
conditions.
We recommend that the vessels engine should always be
used to aid anchor recovery.
Do not attempt to pull a load greater then the rated load of
the windlass.
When the windlass is not in use the anchor must be tied off
onto a cleat or equivalent strong point to prevent damage.
To Next Page
Loading...
