PART 1 IMPORTANT INFORMATION
READ BEFORE INSTALLING OR USING THE AA150
1 The AA150 is a rope and chain or chain only rode counter. It does not control
the windlass. A toggle switch, deck switch or handheld remote is required to
operate the windlass.
may require a sensor holder or a custom designed sensor which is not
included in the standard pack. Check with your supplier or the AutoAnchor
manufacturer.
solenoid pack.
5 Information for installation and operation of the AA150 is supplied including
on board for the owner.
6 Non compliance with the instructions could impair the windlass and the AA150
operation, and could result in personal injury and/or damage to the boat.
7 Non compliance with the instructions will negate the manufacturer’s warranty.
8 The AA150 manufacturer and supplier accept no liability for personal injury
or property damage resulting from failure to follow the installation instructions
or the use of the AA150 in a way that may cause accidents or damage or
11 Installation is not complete until the AA150 has been set up to comply with the
12 All installations must be carried out in accordance with USCG, ABYC, NMMA
and BMEA requirements.
13 This manual supports the installation and use of the AA150 only. The
appropriate manufacturer’s instructions must be followed for the installation
and use of the windlass it is connected to.
14 When this product reaches the end of its useful life it must be disposed of in
accordance with local regulations.
1
TABLE OF CONTENTS
PART 1 IMPORTANT INFORMATION
PART 2 INSTALLATION
PART 3 SET UP
PART 4 USING THE AUTOANCHOR 150
PART 5 MAINTENANCE
PART 6 TROUBLESHOOTING
To Next Page
Loading...
