6
Dual Installation
Part #9505.
Part 9506
2.1.4 REED SWITCH SENSORS
The AutoAnchor will operate with a reed switch sensor for all-chain rode. If using rope/
rope.
For an accurate rope and chain count, the reed switch sensor should be replaced with the
AA grey sensor (#9067).
Magnet Fit
2.1.5 INSTALLATION VERTICAL WINDLASS - CHAIN ONLY
Magnet Size:
Fig 1 - All sensors
Magnet
Sensor
Gap Between the Sensor and Magnet:
Sensor Gap
AA Grey Sensor #9067
AA Grey Sensor #9067
AA Black Sensor #9008 All Magnets
Reed Switch Sensor
Sensor Position:
magnet must be as per the table below.
Chainwheel
Refer to the Overview Notes on page 4 before starting installation.
Sensor Connection:
together. See the information on page 5.
Loose cable should be tied in place with cable ties and kept clear of chain.
7
Sensor
AutoAnchor
560
Console
Up
Down
# 9506
# 9505
Fig 1a - Grey AA sensor
may be offset up to 20mm
Magnet
Sensor
Chainwheel
To Next Page
Loading...
