7.4 V2-6 Independent warping
NOTE: V6 do not have Fall-Safe.
Gypsy/drum only
1. Lock anchor chain before warping.
2. Models V2-3
Engage fall safe pawl.
Models V4-5
Check pawl is in disengaged position.
3. Place a Lewmar winch handle into top nut. Disengage clutch by turning anti-clockwise by half a turn.
Remove handle.
4. When safe, operate the drum.
If warping speed is too fast, ease tension in rope.
When finished re-engage clutch by tightening the drum top nut.
DO NOT wrap chain
around the capstan drum.
WARNING! Always remove
winch handle after use.
To Next Page
Loading...
Need help?
General
