MPX G2 Service Manual
5-18
At the Top Level Tests menu, turn the Encoder until the display reads the following:
Diags: Top Level
SoftwareErrLog >
To view the Error Log, press the >YES button for a display of:
Error Log #1
< E0
To view the other records (#2-10), turn the Encoder CW.
To exit, press the NO< button for a display of:
Diags: Top Level
SoftwareErrLog >
Refer to Appendix A for a list of software error messages.
Clear Err Log
This will erase all error message information that can be stored in the 10 record Error Log.
At the Top Level Tests menu turn the Encoder until the display reads the following:
When selected, the display will read the following:
Diags: Top Level
Clear Err Log >
To clear the Error Log, press the >YES for a display of:
Err log cleared
<
The Error Log is cleared. To exit, press the NO< button for a display of:
Diags: Top Level
Clear Err Log >
2186 Tools
This is a tool used only by the programmers for viewing certain information in each program (preset). It is
not intended to be used as a tool for troubleshooting.
When selected, the display will read the following:
Diags: Top Level
2186 Tools >
To enter the 2186 Tool Menu, press the >YES button.
To view the items in the menu, use the Encoder.
To exit the 2186 Tool Menu and enter the Top Level Menu, press the NO< button.
To Next Page
Loading...
Need help?
General
