Lexicon
5-19
View Alg Nums
This is a tool used only by the programmers for viewing certain information in each program (preset). It is
not intended to be used as a tool for troubleshooting.
When selected, the display will read the following:
Diags: Top Level
View Alg Nums >
To view the information in a program, press the >YES button for a display of:
Program #:201 00
<00 00 00 00 00
To view information in other programs, turn the Encoder CW to select the desired program.
To exit, press the NO< button for a display of:
Diags: Top Level
View Alg Nums >
UTILITY MENU (Options Button)
The Utility Menu will provide several tools for troubleshooting an MPX G2.
The following is a list of the tools available:
Repeat Test
Last Test Result
DRAM Adr (View DRAM at various addresses)
MIDI (MIDI Scope)
This utility is accessible when a test or scope loop is selected. They are available via the Options button.
When the OPTIONS button is pressed, the Utility Menu is accessed and the display reads:
Repeat Test
> 1 times
Pressing the >Yes button at this time will selected the other utilities available.
When viewing Repeat Test, DRAM Adr and MIDI Of, the encoder will be active to change a variable in the
utility.
This is explained in detail as follows.
Repeat Test
This utility allows a test or scope loop to be run 1-254 times or infinitely. It can be used to discover
intermittent failures and in some cases, help troubleshoot a consistent failure. For example, if the MIDI Test
failed, the technician can have the test run continuously to verify what part of the circuit is at fault.
This utility will work with the following tests:
Footpedal WCS
To Next Page
Loading...
Need help?
General
