17
PCM 80 Version 1.10 MIDI Implementation Details
Lexicon
0x1A Effect Information Response
PCM 80 to Host only. This dump allows a remote master to get information about any of the effects in
the box.
Byte # Byte Value Description Notes
1 F0 SysEx ID
2 06 Lexicon ID
3 07 PCM 80 ID
4 0iii iiii Device ID
5 0x1A Effect Information
6 0iii iiii Bank # A bank # of 0x7F and program # of 0x7F indicates the current program.
7 0iii iiii Program #
8-23 0iii iiii Algorithm Name 16 Byte string
24-35 0iii iiii Program Name 12 Byte string
36-44 0iii iiii Knob Name 9 Byte string
45 0xF7 End of SysEx
0x1C Adjust Knob Name Dump
Bidirectional. Name string for the Adjust knob in the current effect.
Byte # Byte Value Description Notes
1 F0 SysEx ID
2 06 Lexicon ID
3 07 PCM 80 ID
4 0iii iiii Device ID
5 0x1C Adjust knob name
6-14 0iii iiii Knob name String 9 Byte string
15 0xF7 End of SysEx
0x1E Verbose Dump Message
This dump is only received by the PCM 80. It is provided for use with remote editors to enable and disable
the flashing of MIDI transmission messages during PCM 80 SysEx dumps. This message can also set
an automatic mode wherein a display message is transmitted whenever the display changes (to support
a remote control). Verbose state is NOT remembered by the PCM 80 over a reboot cycle. The PCM 80
always returns to normal mode (Mode 1).
Byte # Byte Value Description Notes
1 F0 SysEx ID
2 06 Lexicon ID
3 07 PCM 80 ID
4 0iii iiii Device ID
5 0x1E Verbose message
6 0000 00xx 2 (Automatic mode) Do not flash messages on screen. In addition,
automatically send the display SysEx whenever the display changes.
Note that this mode can cause a tremendous amount of data to be output
by the PCM 80, and some computers may have trouble keeping up.
1 (normal mode) Flash messages on screen. Transmit display only when
requested.
0 (quiet mode) Do not flash messages on screen. Transmit display only
when requested. In mode 0 and 2, no MIDI dump status messages are
displayed.
7 0xF7 End of SysEx
To Next Page
Loading...
