10 envelopes
25 sheets of labels
50 transparencies
• The print side of the envelopes faces you.
• The stamp location is in the upper left corner.
• The envelopes are designed for use with inkjet printers.
• The envelopes are loaded in the center of the paper support.
• The paper guides rest against the edges of the envelopes.
Warning--Potential Damage: Do not use envelopes that have metal
clasps,string ties, or metal folding bars.
Notes:
- Do not load envelopes with holes, perforations, cutouts, or deep
embossing.
- Do not use envelopes that have exposed flap adhesive.
- Envelopes require more drying time. Remove each envelope as it
exits, and then allow it to dry to avoid ink smudging.
• The print side of the label sheets faces you.
• The top of the label sheets feeds into the printer first.
• The adhesive on the labels does not extend to within 1 mm of the
edge of the label sheets.
• You usefull label sheets. Partial sheets (with areas exposed by missing
labels) may cause labels to peel off during printing, resulting in a paper
jam.
• The label sheets are loaded in the center of the paper support.
• The paper guides rest against the edges of the label sheets.
Note: Labels require more drying time. Remove each sheet of labels as it
exits, and then allow it to dry to avoid ink smudging.
• The rough side of the transparencies faces you.
• If the transparencies have a removable strip, each strip faces away
from you and down toward the printer.
• The transparencies are loaded in the center of the paper support.
• The paper guides rest against the edges of the transparencies.
Notes:
• Transparencies with paper backing sheets are not recommended.
• Transparencies require more drying time. Remove each transparency
as it exits, and then allow it to dry to avoid ink smudging.
24
To Next Page
Loading...
Need help?
General