Note: The printer reads only one memory device at a time.
Using a PictBridge-enabled digital camera to control printing photos
Connect a PictBridge-enabled digital camera to the printer, and use the buttons on the camera to select and print
photos.
1 Insert one end of the USB cable into the camera.
Note: Use only the USB cable that came with the digital camera.
2 Insert the other end of the cable into the PictBridge port on the front of the printer.
Notes:
• Make sure the PictBridge-enabled digital camera is set to the correct USB mode. For more information, see
the camera documentation.
• The printer reads only one media device at a time.
• If the PictBridge connection is successful, the following appears on the display: PictBridge camera
detected. Press
to change settings. If any other message appears, see “Error messages” on
page 71.
3 Follow the instructions in the camera documentation to select and print photos.
Transferring digital photos to a computer
1 Make sure the printer is connected to a computer, and both the printer and computer are on.
2 Insert a memory card. For more information, see “Inserting a memory card” on page 36.
The Fast Pics dialog appears on the computer screen.
3 Click Save Photos to PC.
The light on the printer blinks to indicate the memory card is transmitting data to the computer.
4 Follow the instructions on the computer screen to specify where you want to save the images.
Browsing and selecting photos stored on the computer
1 Click Start Programs or All Programs Lexmark 3400 Series.
2 Select Imaging Studio.
37
To Next Page
Loading...
