• Do not remove trays while the printer is printing. Wait for Load tray <x> or Ready to appear before removing
a tray.
• Do not load the manual feeder while the printer is printing. Wait for Load manual feeder with <x> to appear.
• Push all trays in firmly after loading media.
• Make sure the guides in the trays are properly positioned and are not pressing too tightly against the paper.
• Make sure all media sizes and media types are set correctly in the control panel menu.
• Make sure all printer cables are attached correctly. For more information, see the setup documentation.
Note: If a jam occurs, clear the entire media path. For information on the media path, see the User's Guide.
Media guide
Page 23 of 34
To Next Page
Loading...
