Lexmark C530 - Page 24

Print defects guide
Repeating defects measurements
Match a set of repeating defects on a print job to the marks on one of the vertical lines. The line that best matches the
defects on the print job indicates which particular part is causing the defect.
Change the photoconductor unit for the color
that shows this defect.
Change the toner cartridge for the color that
shows this defect.
Change the fuser.
72.4 mm
(2.85 inches)
28.3 mm
(1.11 inches)
35.7 mm
(1.41 inches)
33.5 mm
(1.32 inches)
116.2 mm
(4.58 inches)
Print defects guide
Page 24 of 34