4-114 Service Manual
5026
Hard drive assembly removal
Warning: This part might contain customer confidential information. See “Data Security Notice” on page 4-1
for more details. After removing this part, return it to your next level of support so any data can be
removed. If the customer requests to keep the part, they must sign a confirmation of memory device
retention form.
1. Remove the rear frame cover. See “Rear frame cover removal” on page 4-47.
2. Remove the two screws (A), and squeeze the connector to disconnect the hard disk from the system
board (B).
3. Pull the hard disk straight out to pop the hard drive standoffs free of the system board.
To Next Page
Loading...
