Installing memory and option cards
15
Installing and removing options
Installing a hard disk
Follow the instructions in this section to install an optional hard disk. You need a small flathead screwdriver to attach the
hard disk to the mounting plate.
Warning: Hard disks are easily damaged by static electricity. Touch something metal on the printer before you
touch a disk.
If an option card has been installed, you may need to remove it before installing the hard disk.
1 Remove the system board access cover. For more information, see Removing the system board access cover.
2 Remove the mounting plate, hard disk, ribbon cable, and attachment screws from the package.
3 Align the ribbon cable connector with the connector pins on the hard disk.
4 Attach the ribbon cable to the hard disk.
5 Align the screw holes on the mounting plate with the holes in the hard disk.
6 Secure the mounting plate to the hard disk with the screws.
Pins
Hard disk
Ribbon cable
Mounting plate
To Next Page
Loading...
