Removing memory and option cards
18
Installing and removing options
Removing memory and option cards
To remove memory or option cards, use the following illustration to locate the connector for the card you want to remove.
Accessing the printer system board
1 Turn the printer off.
2 Unplug the printer power cord.
3 Disconnect all cables from the back of the printer.
4 Locate the access cover on the back of the printer.
5 Remove the four access cover screws as shown.
6 Remove the access cover.
Firmware and flash
memory card connectors
Option card connector
Hard disk connector
Memory card connector
To Next Page
Loading...
