Menu item Description
Alarms
Alarm Control
Single
Continuous
Off
Cartridge Alarm
Single
Continuous
Off
Staple Alarm
Off
Single
Continuous
Hole Punch Alarm
Off
Single
Continuous
Sets an alarm to sound when the printer requires operator
intervention
Notes:
• Single is the factory default setting for Alarm Control and
Cartridge Alarm. Single sounds three quick beeps.
• Off is the factory default setting for Staple Alarm and Hole
Punch Alarm.
• Continuous repeats three beeps every 10 seconds.
Timeouts
Standby Mode
Disabled
2–240
Specifies the number of minutes of inactivity before the system
enters a lower power state
Note: 15 minutes is the factory default setting.
Timeouts
Sleep Mode
Disabled
1–240
Specifies the number of minutes of inactivity before some
systems begin entering a minimum power state
Notes:
• 30 minutes is the factory default setting.
• A lower setting conserves more energy, but may require
longer warm-up times.
• Select the lowest setting if the printer shares an electrical
circuit with room lighting.
• Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm-up time.
• Sleep Mode does not interact with Standby Mode.
Timeouts
Screen Timeout
15–300
Sets the amount of time (in seconds) the printer waits before
returning to a Ready state
Note: 30 seconds is the factory default setting.
Understanding printer menus
129
To Next Page
Loading...
