22
Set up the printer and paper handling options
2 Place the high-capacity feeder on
the floor or adequate work
surface.
3 Remove the four screws securing
one of the casters to the high-
capacity feeder.
4 Add or remove spacers.
To add spacers:
a Insert the four screws through
the caster.
b Place the spacers on the
screws.
c Align and insert the screws
into the screw holes on the
high-capacity feeder.
To remove the factory installed
spacer:
a Remove the spacer from the
top of the caster.
b Insert the four screws through
the caster.
c Align and insert the screws
into the screw holes on the
high-capacity feeder.
5 Tighten the four screws to secure
the caster to the high-capacity
feeder.
6 Repeat steps 3 through 5 to add
or remove spacers on the
remaining three casters.
7 Return to step 5 on page 19.
To Next Page
Loading...
