28
Install memory and option cards
4 Align the notches on the bottom of
the card with the notches on the
connector.
5 Push the memory card firmly into
the connector until the latches on
either end of the connector snap
into place.
It may require some force to fully
seat the card.
6 Make sure each latch fits over the
notch on the end of the card.
Installing a
firmware card
Follow the instructions in this section to
install a firmware card.
If you have a Lexmark C910in, an
ImageQuick™ firmware card is already
installed.
Note: Firmware cards designed for
other Lexmark printers may not work
with your printer.
If an option card has been installed, you
need to remove the option card before
installing the firmware card.
1 Remove the system board access
cover (see page 24).
To Next Page
Loading...
