Lexmark C910 - Page 282

PostScript
4-86
InstalledRam integer (Read-only) Indicated, in bytes, the total amount of installed
printer memory (RAM) in the system.
Note: InstalledRam should not be confused with RamSize
which is the amount of memory (RAM) available to the
formatting interpreters and the graphics engine.
JobTimeout integer The value in seconds to which the user parameter
JobTimeout is initialized at the beginning of each print job. If
you set the system parameter JobTimeout to a negative
value, it is ignored and the previous setting of JobTimeout is
used. A value of 0 (zero) indicates that the timeout is infinite.
If you set a number between 1 and 14, 15 is set.
Legal values: x = 0, 15 <= x <= 65355
MaxDisplayAndSourceList
2
integer (Read-only) This value is always the same value as
InstalledRam.
MaxDisplayList integer (Read-only) See Table C-4 on page C-10 for the default value
of your printer.
MaxFontCache integer (Read-only) See Table C-4 on page C-10 for the default value
of your printer.
MaxFormCache integer Maximum bytes occupied by the form cache.
Legal value: Any non-negative integer.
MaxImageBuffer integer (Read-only) See Table C-4 on page C-10 for the default value
of your printer.
MaxOutlineCache integer (Read-only) See Table C-4 on page C-10 for the default value
of your printer.
MaxPatternCache integer Maximum bytes occupied by the pattern cache.
Legal value: Any non-negative integer.
MaxPermanentVM
2
integer (Read-only) See Table C-4 on page C-10 for the default value
of your printer.
MaxRasterMemory integer (Read-only) See Table C-4 on page C-10 for the default value
of your printer.
MaxScreenStorage integer (Read-only) See Table C-4 on page C-10 for the default value
of your printer.
MaxSourceList integer (Read-only) See Table C-4 on page C-10 for the default value
of your printer.
MaxUPathCache integer Maximum bytes occupied by the user path cache.
Legal value: Any non-negative integer.
PageCount integer (Read-only) Total number of pages that have been printed.
PanelCode
1
string (Read-only) Version of the operator panel code.
Table 4-20: PostScript Emulation System Parameters (Continued)
Key Type Definition
1
These parameters are Lexmark-specific and are in addition to the Adobe PostScript Language Supplement 2016.
2
These parameters are available with the Adobe PostScript Language Supplement 3010.
3
These parameters are Lexmark-specific and are in addition to the Adobe PostScript Language Supplement 3010.