Printer had to restart. Last job may be incomplete.
From the printer control panel, press to clear the message and continue printing.
For more information, go to
http://support.lexmark.com or contact customer support.
Rear USB port disabled [56]
Try one or more of the following:
• From the printer control panel, press to clear the message and continue printing.
Note: The printer discards any data received through the USB port.
• From the printer control panel, set USB
Buer
to Auto.
Reinstall missing or unresponsive [color] cartridge [31.xy]
Try one or more of the following:
• Install the missing toner cartridge. For more information, see the “Replacing supplies” section of the
User’s Guide.
• Remove the unresponsive cartridge, and then reinstall it.
Note: If the message appears after reinstalling the supply, then the cartridge may be defective.
Replace the cartridge.
Reinstall missing or unresponsive black and color imaging kit and all
cartridges [31.xy]
Try one or more of the following:
• Check if the imaging kit is missing. If missing, then install the imaging kit.
For information on installing the imaging kit, see the “Replacing supplies” section.
• If the imaging kit is installed, then remove and reinstall the unresponsive imaging kit.
Note: If the message appears after reinstalling the supply, then replace the imaging kit. The imaging
kit may be defective or a non‑genuine Lexmark supply. For more information, see
“Using genuine
Lexmark parts and supplies” on page 96.
Reload printed pages in Tray [x]
Try any of the following:
• From the printer control panel, press to clear the message and continue printing the second side
of the sheet.
• From the printer control panel, press to cancel the print job.
Troubleshooting 134
To Next Page
Loading...
Need help?
General
