Lexmark CS317 User Manual

Use To
USB Buer
Disabled
Auto
3K to [maximum size allowed]
Set the size of the USB input buer.
Notes:
• Auto is the factory default setting.
• Disabled turns o job buering. Any jobs already buered in the printer
hard disk are printed before normal processing resumes.
• The USB buer size value can be changed in 1KB increments.
• The maximum size allowed depends on the amount of memory in the
printer, the size of the other link buers, and whether Resource Save is
enabled or disabled.
• To increase the maximum size range for the USB Buer, disable or
reduce the size of the parallel, serial, and network buers.
• The printer automatically restarts when the setting is changed from the
printer control panel. The menu selection is then updated.
Mac Binary PS
On
O
Auto
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
• Auto is the factory default setting.
• On processes raw binary PostScript print jobs.
• O filters print jobs using the standard protocol.
ENA Address
yyy.yyy.yyy.yyy
Set the network address, netmask, and gateway information for an external print
server.
Note: This menu is available only when the printer is attached to an external
print server through the USB port.
ENA Netmask
yyy.yyy.yyy.yyy
ENA Gateway
yyy.yyy.yyy.yyy
Security menu
Set Date and Time menu
Use To
Current Date and Time View the current date and time settings for the printer.
Manually Set Date and Time Enter the date and time.
Notes:
• Date/Time is set in YYYY-MM-DD HH:MM:SS format.
• Manually setting the date and time sets “Enable NTP” (Network Time
Protocol) to On.
Time Zone Select the time zone.
Note: GMT is the factory default setting.
Understanding the printer menus 67

Lexmark CS317 Specifications

General

Brand	Lexmark
Model	CS317
Category	Printer
Language	English