Lexmark CX532 - Setting up the printer to fax

Setting up the printer to fax
Supported fax
Printer model Analog fax
etherFAX
1
Fax server
2
Fax over IP (FoIP)
3
CX532
CX635
XC2335
1
Needs a subscription. For more information, go to https://www.etherfax.net/lexmark or contact the place where
you purchased the printer.
2
Needs a subscription for the fax server to work.
3
Needs an installed license bundle. For more information, contact the place where you purchased the printer.
Setting up the fax function using analog fax
Notes:
• Some connection methods are applicable only in some countries or regions.
• If the fax function is enabled and not fully set up, then the indicator light may blink red.
• If you do not have a TCP/IP environment, then use the control panel to set up fax.
Warning—Potential Damage: To avoid loss of data or printer malfunction, do not touch cables or the printer
in the area shown while actively sending or receiving a fax.
Using the control panel
1
From the home screen, touch Settings > Fax > Fax Setup > General Fax Settings.
2
Configure
the settings.
Set up, install, and configure 33