Lexmark CX930 - Page 23

Paper sizes supported by the finishers
Paper size Staple finisher Staple, hole punch finisher
Stack Oset Staple Stack Oset Staple Hole punch
A3
1
297 x 420 mm
(11.69 x 16.54 in.)
A4
210 x 297 mm
(8.27 x 11.7 in.)
A5
148 x 210 mm
(5.83 x 8.27 in.)
2
X
2 2 6
A6
105 x 148 mm
(4.13 x 5.83 in.)
XX XXX
Banner
Maximum width:
215.9 mm (8.5 in.)
Maximum length:
1320.8 mm (52 in.)
1
XX
1
XXX
Executive
184.2 x 266.7 mm
(7.25 x 10.5 in.)
2 2 2 2 2 2
Folio
1
215.9 x 330.2 mm
(8.5 x 13 in.)
Hagaki
100 x 148 mm
(3.94 x 5.83 in.)
XX XXX
1
Loads only in short‑edge orientation.
2
Loads only in long‑edge orientation.
3
Supports paper sizes ranging from 88.9 x 98.38 mm (3.5 x 3.87 in.) to 296.93 x 431.8 mm (11.69 x 17 in.).
4
Supports paper sizes ranging from 190 x 139.7 mm (7.48 x 5.5 in.) to 296.93 x 431.8 mm (11.69 x 17 in.).
5
Supports paper sizes ranging from 202.9 x 182.03 mm (7.99 x 7.17 in.) to 296.93 x 431.8 mm (11.69 x 17 in.).
6
Supports only up to 2‑hole punching.
7
Supports only up to 2‑hole punching when loaded in short‑edge orientation.
8
Supports paper sizes ranging from 88.9 x 98.38 mm (3.5 x 3.87 in.) to 320.04 x 1320.8 mm (12.6 x 52 in.).
9
Supports paper sizes ranging from 209.97 x 148 mm (8.27 x 5.83 in.) to 296.93 x 431.8 mm (11.69 x 17 in.).
Learn about the printer 23