Lexmark CX930 - Setting up the Printer to Fax

Adjusting the Voice Guidance speech rate
1 From the home screen, touch Settings > Device > Accessibility > Speech Rate.
2 Select the speech rate.
Adjusting the default headphone volume
1 From the home screen, touch Settings > Device > Accessibility.
2 Adjust the headphone volume.
Note: The volume resets to the default value after the user exits Accessibility mode or when the printer
wakes from Sleep or Hibernate mode.
Adjusting the default internal speaker volume
1 From the home screen, touch .
2 Adjust the volume.
Notes:
• If Quiet Mode is enabled, then audible alerts are turned o. This setting also slows the printer
performance.
• The volume resets to the default value after the user exits Accessibility mode or when the printer wakes
from Sleep or Hibernate mode.
Enabling spoken passwords or personal identification numbers
1 From the home screen, touch Settings > Device > Accessibility > Speak Passwords/PINs.
2 Enable the setting.
Setting up the printer to fax
Supported fax
Printer model
Analog fax
1
etherFAX
2
Fax server
Fax over IP (FoIP)
3
CX930
CX931
XC9325
1
Needs an installed fax card. For more information, contact the place where you purchased the printer.
2
Needs a subscription. For more information, go to https://www.etherfax.net/lexmark or contact the place where
you purchased the printer.
3
Needs an installed license bundle. For more information, contact the place where you purchased the printer.
Set up, install, and configure 39