Lexmark CX930 - Page 238

Menu item Description
Paper Source
Tray [x] (1*)
Multipurpose Feeder
Manual Paper
Manual Envelope
Set the paper source for the print job.
Collate
(1,1,1) (2,2,2)
(1,2,3) (1,2,3)*
Keep the pages of a print job stacked in sequence, particularly when printing
multiple copies of the job.
Sides
1‑Sided*
2‑Sided
Specify whether to print on one side or both sides of the paper.
Staple
O*
1 staple, top left corner
2 staples, left
1 staple, top right corner
2 staples, top
1 staple, bottom left corner
2 staples, bottom
1 staple, bottom right corner
2 staples, right
4 staples
Specify the staple position for all print jobs.
Note: This menu item appears only when a staple
finisher
is installed.
Hole Punch
O*
2 holes
3 holes
4 holes
Set the punch mode for all print jobs.
Note: This menu item appears only when a staple, hole punch finisher is
installed.
Oset Pages
None*
Between Copies
Between Jobs
Oset the output of each print job or each copy of a print job.
Notes:
• Between Copies osets each copy of a print job if Collate is set to On
[1,2,1,2,1,2]. If Collate is set to O [1,1,1,2,2,2], then each set of printed pages is
oset, such as all pages designated as 1 and all pages designated as 2.
• Between Jobs sets the same oset position for the entire print job
regardless of the number of copies printed.
Flip Style
Long Edge*
Short Edge
Determine which side of the paper is bound when performing two‑sided printing.
Note: An asterisk (*) next to a value indicates the factory default setting.
Use printer menus 238