If the supplemental light sequence matches the light sequence in the preceding illustration, then try one or more of
the following:
• Remove the imaging unit, and then reinstall it.
• Remove the imaging unit, and then install a new one. For more information, see the instruction sheet that came
with the supply.
Replace unsupported imaging unit [32.xy]
‑ On
‑ On
‑ On
‑ Blinking
If the printer control panel light sequence matches the light sequence in the preceding illustration, then remove the
imaging unit, and then install a supported one. For more information, see the instruction sheet that came with the
supply.
Note: If you do not have a replacement imaging unit, then see the “Ordering supplies” section of the User’s Guide or
visit
www.lexmark.com.
54
To Next Page
Loading...
