Lexmark MS415dn User Manual

Use To
Activate Hex Trace Isolate the source of a print job problem.
Notes:
• When activated, all data sent to the printer is printed in hexadecimal and
character representation, and control codes are not executed.
• To exit or deactivate Hex Trace, restart the printer.
Coverage Estimator
O
On
Provide an estimate of the percentage coverage of toner on a page. The
estimate is printed on a separate page at the end of each print job.
Note: O is the factory default setting.
PCL Emul menu
Use To
Font Source
Resident
Download
Flash
All
Specify the set of fonts used by the Font Name menu.
Notes:
• Resident is the factory default setting. This shows the factory default
set of fonts downloaded in the RAM.
• Download shows all the fonts downloaded in the RAM.
• Flash shows all fonts resident in that option. The optional flash
memory card must be properly formatted and cannot be read/write‑,
write‑, or password‑protected.
• All shows the fonts available to any option.
Font Name
Courier 10
Identify a specific font and the option where it is stored.
Note: Courier 10 is the factory default setting. This shows the font name,
font ID, and the storage location in the printer. The font source
abbreviation is R for Resident, F for Flash, and D for Download.
Symbol Set
10U PC‑8
12U PC‑850
Specify the symbol set for each font name.
Notes:
• 10U PC‑8 is the U.S. factory default setting. 12U PC‑850 is the
international factory default setting.
• A symbol set is a set of alphabetic and numeric characters,
punctuation, and special symbols. Symbol sets support the dierent
languages or
specific
program, such as math symbols for
scientific
text. Only the supported symbol sets are shown.
PCL Emulation Settings
Point Size
1.00–1008.00
Change the point size for scalable typographic fonts.
Notes:
• 12 is the factory default setting.
• Point size refers to the height of the characters in the font. One point
equals approximately 0.014 inch.
• Point sizes can be increased or decreased in 0.25‑point increments.
Understanding the printer menus 115

Lexmark MS415dn Specifications

General

Print Technology	Laser
Print Speed	Up to 40 ppm
Print Resolution	1200 x 1200 dpi
Processor Speed	800 MHz
Duplex Printing	Yes
Maximum Paper Size	8.5 x 14 inches
Operating System Compatibility	Windows, Mac OS, Linux
Memory	256 MB
Input Capacity	250 sheets
Connectivity	USB, Ethernet
Dimensions	10.3 x 15.7 x 15.0 inches