Lexmark MX310 Series - Serial option [x] error [54]; SMTP server not set up. Contact system administrator.; Standard network software error [54]; Standard USB port disabled [56]

• For non‑touch‑screen printer models, press to confirm.
Scanner jam, remove all originals from the scanner [2yy.xx]
Remove the jammed paper from the scanner.
Scanner jam, remove jammed originals from the scanner [2yy.xx]
Remove the jammed paper from the scanner.
Serial option [x] error [54]
Try one or more of the following:
• Make sure that the serial cable is properly connected and is the correct one for the serial port.
• Make sure that the serial interface parameters (protocol, baud, parity, and data bits) are set correctly on the printer
and computer.
• From the printer control panel, select Continue to continue printing. For non‑touch‑screen printer models, press
to confirm.
• Turn off the printer, and then turn it back on.
SMTP server not set up. Contact system administrator.
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models, press
to confirm.
Note: If the message appears again, then contact your system support person.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, select Continue to continue printing. For non‑touch‑screen printer models, press
to confirm.
• Turn off the printer and then turn it back on.
• Update the network firmware in the printer or print server. For more information, contact customer support.
Standard USB port disabled [56]
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models, press
to confirm.
Notes:
• The printer discards any data received through the USB port.
Troubleshooting 194