32.28
32.31
32.34
32.37
For more information, see
“Using genuine Lexmark parts and supplies” on page 209.
Note: If you do not have a replacement cartridge, then see the “Ordering supplies” section or go to
www.lexmark.com.
Replace unsupported imaging unit [32.xy]
Remove the imaging unit, and then install a supported one to clear the message and continue printing. For
more information, see the instruction sheet that came with the supply.
This error can also be caused by installing a genuine Lexmark imaging unit, such as a MICR unit, that is not
intended to be used in this product.
The following error c
odes indicate that a non‑genuine Lexmark imaging unit is installed:
32
.38
For more information, see
“Using genuine Lexmark parts and supplies” on page 209.
Note: If you do not have a replacement imaging unit, then see the “Ordering supplies” section or visit
www.lexmark.com.
Restore held jobs?
Try one or more of the following:
• From the printer control panel, select Restore to restore all held jobs stored in the printer hard disk.
For non‑touch‑screen printer models, press
to confirm.
• From the printer control panel, select Do not restore if you do not want any print jobs to be restored.
For non‑touch‑screen printer models, press
to
confirm.
Scanner automatic feeder cover open
Close the ADF cover.
Troubleshooting 243
32.14
32.17
32.20
32.23
32.26
32.29
32.32
32.35
To Next Page
Loading...
