Lexmark MX417 Series - Page 245

Standard USB port disabled [56]
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models,
press
to
confirm.
Notes:
• The printer discards any data received through the USB port.
• Make sure the USB
Buer
menu is not set to Disabled.
Supply needed to complete job
Do either of the following:
• Install the missing supply to complete the job.
• Cancel the current job.
The device is operating in Safe Mode. Some print options may be disabled
or provide unexpected results.
Select Continue to clear the message. For non‑touch‑screen printer models, press to confirm.
Too many flash options installed [58]
1 Turn
o
the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra
flash
memory.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Too many trays attached [58]
1 Turn
o
the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra trays.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Troubleshooting 245