3
Flex, fan, and align the paper edges before loading.
4
Load the paper stack with the printable side facedown, and
then make sure that the side guides fit snugly against the
paper.
•
Do not slide paper into the tray.
•
To avoid paper jams, make sure that the stack height is
below the maximum paper
fill
indicator.
•
Load letterhead depending on whether an optional staple
finisher
is installed or not.
Without an optional staple
finisher
With an optional staple finisher
One‑sided printing
One‑sided printing
Without an optional staple
finisher
With an optional staple
finisher
Two‑sided printing
Two‑sided printing
•
When loading prepunched paper, make sure that the holes
on the long edge of the paper are against the right side of
the tray.
One‑sided printing Two‑sided printing
•
Load envelopes with the flap side up and against the left
side of the tray.
Warning—Potential Damage: Do not use envelopes with
stamps, clasps, snaps, windows, coated linings, or
self
‑
stick adhesives.
5
Insert the tray.
6
From the control panel, set the paper size and paper type to
match the paper loaded.
10
To Next Page
Loading...
