21
Load paper
Loading
500-sheet trays
Follow these instructions to load A4 or
letter size paper into a 500-sheet tray,
depending on which tray you purchased.
Do not exceed the recommended
capacity (see page 15).
1 Remove the tray, and then set it
on a flat surface.
2 Remove the tray cover.
Make sure all packing materials
have been removed from inside
the tray.
3 Flex the sheets of paper back and
forth to loosen them, and then fan
them.
Do not fold or crease the paper.
Straighten the edges of the stack
on a level surface.
4 Place the paper against the back
of the tray, print side up.
Make sure the paper is under both
corner bucklers and lying flat in
the tray.
5 Replace the tray cover.
6 Insert the tray.
7 Select the paper type and paper
source from the operator panel.
You will also need to select the
paper size, type, and source from
your software application when
you send a job to print.
To Next Page
Loading...
