32
Install memory, firmware, or option cards
Reinstalling the system
board access panel
Follow these instructions to reinstall the
printer system board access cover and
panel.
1 Insert the metal tab on the bottom
of the access panel behind the
printer frame, and then secure the
panel with the screws.
2 Insert the two tabs at the front of
the right cover behind the printer
frame, and then align the back of
the cover.
3 Slide the right cover forward.
Be sure the cover securely
engages with the printer frame.
4 Close the top cover.
If you installed a firmware card in your
printer, see the following section for
information about applying the Option
Added label.
To Next Page
Loading...
