37
Verify printer setup
Step 10: Verify printer setup
Turning on
the printer
1 Plug one end of the power cord into the socket at the back of
the printer and the other end into a properly grounded outlet.
2 Turn on the printer. If the printer is attached locally (directly to a
computer), leave the computer and any other attached devices
turned off. You will turn these on in a later step.
The message Performing Self Test appears on the
operator panel display while the printer warms up.
After the printer completes its internal tests, the Ready
message indicates the printer is ready to receive jobs. If you
see a message other than Ready, refer to the Publications CD
for instructions on clearing the message. Click Printing, and
then Understanding printer messages.
Printing a menu
settings page
Print a menu settings page to review the default printer settings and
to verify that printer options are installed correctly.
1 Press Menu until you see Utilities Menu, and then press Select.
2 Press Menu until you see Print Menus, and then press Select
to print the page.
The message Printing Menus appears on the display.
3 Verify that the options you installed are correctly listed under
“Installed Features.”
If an option you installed is not listed, turn the printer off, unplug
the power cord, and reinstall the option.
4 Verify the amount of memory installed is correctly listed under
“Printer Information.”
1
Menu
2
Select
3
Go
5
Stop
6
Utilities Menu
Return
4
To Next Page
Loading...
