Scanning
Copying
Printing
Scanning
Faxing
Troubleshooting
52
Basics
Index
www.lexmark.com
Lexmark X125
12 Click OK.
13 Click OK again.
Calibrating the scanner
If you see streaks in your scanned or copied images, you may need to calibrate the scanner.
To start the scanner calibration:
1 Place a clean, white sheet of paper in the document support.
2 Press Setup.
3 Press Menu until Maintenance appears on the top line of the display.
4 Press Options until Scanner Init appears on the bottom line.
5 Press Start/Yes.
Note: Starting the scanner calibration takes approximately one minute.
To Next Page
Loading...
