Reconnect power supply
1 Press to turn the printer off.
2 Disconnect the power cord from the wall outlet.
3 Gently remove the power supply from the printer.
4 Reconnect the power supply to the printer.
5 Plug the power cord into the wall outlet.
6 Press to turn the printer on.
Uninstall and reinstall software
Uninstall the printer software, and then reinstall it. For more information, see “Uninstalling and reinstalling the
software” on page 66.
Cannot print from digital camera using PictBridge
These are possible solutions. Try one or more of the following:
Enable PictBridge printing from camera
Enable PictBridge printing on the camera by selecting the correct USB mode. For more information, see the digital
camera documentation.
Make sure the camera is a PictBridge-enabled digital camera
1 Disconnect the camera.
2 Connect a PictBridge-enabled digital camera to the PictBridge port. See the digital camera documentation to
determine whether the camera is PictBridge-enabled.
Check USB cable
Use only the USB cable that came with the camera.
Remove memory cards
Remove any memory cards from the printer.
Check messages
If an error message appears on the display, see “Error messages” in the “Troubleshooting” chapter of the User's
Guide on the CD.
Wireless troubleshooting
Printing a network setup page
A network setup page lists your network configuration settings.
Note: You can print a network setup page only after a print server has been installed.
To print a network setup page:
1 From the control panel of the printer, press Settings.
2 Press or repeatedly until Network Setup appears.
50
To Next Page
Loading...
