PJL
3-55
• LPARM:POSTSCRIPT is used for variables specific for PostScript emulation.
(See the tables “Common Variables for PostScript Emulation” on page 3-51,
and “Printer Unique Variables for PostScript Emulation” on page 3-52.)
• LRESOURCE:"device:filename.filetype" is required for LRESOURCE vari-
ables. (See the table “Printer Unique LRESOURCE Variables” on
page 3-53.)
Values for "
device:filename.filetype" are:
device flash, flash1, disk, or disk1 (case insensitive)
filename A unique identifier for a file, such as the macro ID for a PCL
macro, the symbol set ID for a PCL symbol set, the font ID
for a PCL font, and so on. The
filename is case sensitive.
filetype An identifier that categorizes the file, such as p5macro for
PCL macros or
p5symset for PCL symbol sets. See the
table beginning on page 3-87 for a complete list of the
supported file types. The
filetype is case sensitive.
variable=value
The supported variables are listed in the tables beginning on page 3-12.
This printer returns a ? for inquiries of an unsupported variable, or inquiries of a
variable associated with an option that is not installed.
ECHO Command
The ECHO command instructs the printer to return the specified words after the
command is parsed. This command provides a method of capturing the status
information returned by a specific print job.
Syntax:
@PJL ECHO [words][<CR>]<LF>
Response Syntax:
@PJL ECHO [words]<CR><LF>
<FF>
words
parameter
The
words parameter must start with a printable character and can consist of a
combination of printable characters, spaces, and horizontal tabs.
To Next Page
Loading...
