14
Setting defaults
If you are usually copying and scanning using a particular setting, like a
certain size paper, you may want to set this as your default. If you are using
your printer with a computer, you must make changes using both the
operator panel and the Scan & Copy Control Program.
Using the operator panel: Using the computer:
Make sure:
• Paper Size is set to desired paper
size
• Copy Source Size is set to desired
copy size
1 Press
Menu.
2 Press until Language or
Copy Source Size appears on the
display, and then press Select.
3 Press until the desired
setting appears on the display, and
then press
Select.
4 Press Menu.
5 Press until Set Defaults
appears on the display, and then
press
Select.
Make sure:
• Paper Size is set to desired paper
size in your printer settings
• The area to be scanned is set to the
desired paper size in the Scan &
Copy Control Program
1 From your program File menu, select
Print.
2 To customize print settings, click
Properties or Printer Preferences.
3 Select the Paper tab and select the
paper size you want, and then click
OK.
4 Click Start Programs
Lexmark 85 Scan & Copy Control
Program.
5 Click File Setup, and then select
the Page tab.
6 Select the paper size you want, and
then click OK.
or
or
or
To Next Page
