d
Squeeze the length guide and slide it to the correct position
for the size of the paper being loaded until it clicks into
place.
3
Flex sheets of paper back and forth to loosen them, and then
fan them. Do not fold or crease the paper. Straighten the edges
on a level surface.
4
Load the paper stack with the printable side facedown.
Note: Make sure the paper is loaded properly.
•
There are dierent ways of loading letterhead depending
on whether an optional staple finisher is installed or not.
Without an optional staple
finisher
With an optional staple
finisher
ABC
One‑sided printing
ABC
One‑sided printing
ABC
Two‑sided printing
ABC
Two‑sided printing
•
If you are loading prepunched paper for use with the staple
finisher, then make sure the holes on the long edge of the
paper are on the right side of the tray.
One‑sided printing Two‑sided printing
ABC
ABC
Note: If the holes on the long edge of the paper are on
the left side of the tray, then a jam may occur.
11
To Next Page
Loading...
