Section 3
49
Touch on the console display and this will lead to the
Send Tones screen.
After a connection is made, if is touched on the console
display, the tone signals will be sent in units separated by w ’s.
When tone signals are being sent, the send button will change
color. The button will return to its original color when it is ready
send more data.
When
is touched on the console display, unison sending will be can-
celled and the Send Tone screen will be displayed.
The call can be terminated by pressing the hook key on the
command module, or by touching
on the console display.
When
on the console display is touched during the send-
ing of the tone signals, it will cancel the tone signal transmis-
sion and return to the Call screen. In this state, when
on
the console display is touched, the system will return to the
initial Send Tones screen and the tones will start to resend.
INFORMATION
• When all data has been sent, the Send Tone screen will be
displayed.
• Sent data will be deleted from the upper window and the re-
maining data will shift to the left.
• While the vehicle is in motion, the data to be sent in the up-
per window will be converted and displayed as ”_”. When the
vehicle stops, the data will reappear in the upper window
• The system will return to the Call screen when
is touched on
the console display.
To Next Page