Lexus Park Assist System
104
UNL401
Sensors
The Lexus park assist system will help
you to park easily by detecting any ob-
stacle around your vehicle with ultrason-
ic sensors and informing you of the
approximate distance from the vehicle to
the obstacle with the indicators on the
display and with beeping sounds.*
This system will operate at a vehicle speed
of less than about 10 km/h (6 mph) with the
selector lever in a position other than “P”.
NOTE: *The display of the Lexus park as-
sist system screen can be activated or de-
activated. The volume of the beeps can
be changed. See page 106 for details.
UNL402a
You can use this system in either of the
following ways.
Push the main switch of the Lexus park
assist system with the ignition on. A beep
sounds for one second. After the system
self–check is performed, the Lexus park
assist system screen appears for 2 sec-
onds.
Push the main switch of the Lexus park
assist system and turn the ignition on.
The Lexus park assist system screen ap-
pears for 2 seconds and a system self–
check is performed. At this time, a beep
does not sound.
Up to 4 indicator bars are shown on the front
and rear sides of the vehicle mark and up to
3 indicator arcs are shown on each corner of
the vehicle mark. The number of indicators
shows the approximate range up to the ob-
stacle. The indicator marks disappear one–
by–one as your vehicle comes closer to the
obstacle. Also, as you get closer to the ob-
stacle, the beeping interval becomes short-
er.
To turn off the system, push the main switch
again.
NOTICE
If an accident should occur, the
sensors will be affected, resulting in
a system failure.
If the indicators remain on the
display but you do not hear a
beeping sound, the system may be
malfunctioning. Contact your Lexus
dealer.
To Next Page
Loading...
