Audio System
142
Setting a single compact disc:
1. Push the “LOAD” button briefly.
The green indicators at both ends of the slot
start blinking and “WAIT” appears on the dis-
play. After the blinking indicators stay on and
the “WAIT” changes to the “LOAD”, the CD
door opens.
2. Insert only one disc while the CD door
is open.
You can set a disc at the lowest empty disc
number.
After insertion, the set disc is automatically
loaded.
If the label faces down, the disc cannot be
played. In this case, “CD CHECK” appears
on the display.
If you need to insert the next disc, repeat the
same procedure to insert another disc.
Setting all the discs:
1. Push the ”LOAD” button until you hear
a beep.
The green indicators at both ends of the slot
start blinking and “WAIT” appears on the dis-
play. After the blinking indicators stay on and
the “WAIT” changes to the “LOAD”, the CD
door opens.
2. Insert only one disc while the CD door
is open.
The CD door closes and “WAIT” appears
again.
3. Insert the next disc after the “WAIT”
changes to the “LOAD” and the CD door
opens.
4. Repeat this procedure until you insert
all the discs.
To cancel the operation, push the “LOAD” or
“DISC” button.
If you do not insert the discs within 15 sec-
onds after pushing the ”LOAD” button and
“LOAD” is displayed, the operation will be
canceled automatically.
NOTICE
Do not insert one disc stacked on top of
another one or feed them in continu-
ously, to prevent discs from getting
stuck in the player.
To Next Page
Loading...
