148
3-3. Adjusting the seats
1 Check that the shift lever is in P.
2 Turn the power switch to ON
mode.
3 Adjust the driver’s seat, steering
wheel, outside rear view mirrors (if
equipped) and head-up display to
the desired positions, and the Digi-
tal Side-view Monitor (if equipped)
to the desired display range.
4 While pressing the “SET” button, or
within 3 seconds after the “SET”
button is pressed, press button “1”,
“2” or “3” until the buzzer sounds.
If the selected button has already been
preset, the previously recorded position
will be overwritten.
Vehicles with position memory for the
front passenger’s seat: To record the
position of the front passenger’s seat,
adjust the front passenger’s seat to the
desired position and perform step 4
using the buttons on the front passen-
ger’s side.
Q Seat positions that can be memorized
(P.145)
The positions adjusted by the following pro-
cedure can be recorded:
O Seat position adjustment
O Seatback adjustment
O Seat cushion (front) angle adjustment
O Vertical height adjustment
Q In order to correctly use the driving
position memory function
If a seat position is already in the furthest
possible position and the seat is operated in
the same direction, the recorded position
may be slightly different when it is recalled.
1 Check that the shift lever is in P.
2 Turn the power switch to ON
mode.
3 Press one of the buttons for the
driving position you want to recall
until the buzzer sounds.
Q To stop the position recall operation
part-way through
Perform any of the following:
O Press the “SET” button.
Recording a driving position into
memory
Q Seat adjustment caution
Take care during seat adjustment so that
the seat does not strike the rear passen-
ger or squeeze your body against the
steering wheel.
Recalling a driving position
To Next Page
Loading...
