348
5-6. Using the other interior features
device placed on the charge area, remove
the cover and accessories.
Q While charging, noise enters the AM
radio
Turn off the wireless charger and confirm
that the noise has decreased. If the noise
decreases, continuously pushing the power
supply switch of the wireless charger for 2
seconds, the frequency of the charger can
be changed and the noise can be
reduced.Also, on that occasion, the opera-
tion indicator light will flash orange 2 times.
Q Important points of the wireless charger
O If the electronic key cannot be detected
within the vehicle interior, charging can-
not be done. When the door is opened
and closed, charging may be temporarily
suspended.
O When charging, the wireless charging
device and portable device will get
warmer, however this is not a malfunc-
tion.
When a portable device gets warm while
charging, charging may stop due to the
protection function on the portable
device side. In this case, when the tem-
perature of the portable device drops
significantly, charge again.
Q Operation sounds
When the power supply is turned on, while
searching for the portable device a sound
will be produced, however this is not a mal-
function.
Q Caution while driving
When charging a portable device, for
safety reasons, the driver should not
operate the main part of the portable
device while driving.
Q Caution regarding interference with
electronic devices
People with implantable cardiac pace-
makers, cardiac resynchronization ther-
apy-pacemakers or implantable
cardioverter defibrillators, as well as any
other electrical medical device, should
consult their physician about the usage of
the wireless charger. The operations of
the wireless charger may have an affect
on medical devices.
Q To prevent damage or burns
Observe the following precautions.
Failure to do so may result in a possibility
of equipment failure and damage, catch
fire, burns due to overheat.
O Do not insert any metallic objects
between the charging area and the
portable device while charging
O Do not attach stickers, metallic
objects, etc., to the charger area or
portable device
O Do not cover with cloth, etc., and
charge
O Do not charge portable devices other
than designated
O Do not attempt to dismantle for disas-
sembly or modifications
O Do not hit or apply a strong force
Q Conditions in which the function may
not operate correctly
In the following conditions, it may not
operate correctly
O The portable device is fully charged
O There is foreign matter between the
charge area and portable device
O The temperature of the portable
device gets higher from charging
To Next Page
Loading...
