189
2-1. Driving procedures
2
When driving
LX570_OM_OM60L96U_(U)
Turn signal lever
■ Turn signals can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
■ If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned out.
■ If the turn signals stop flashing before a lane change has been performed
Operate the lever again.
■ To discontinue flashing of the turn signals during a lane change
Operate the lever in the opposite direction.
■ Customization
The number of times the turn signals flash during a lane change can be changed.
(Customizable features P. 912)
Right turn
Left turn
Lane change to the right
(move the lever partway and
then release it)
The right hand signals will flash
3 times.
Lane change to the left
(move the lever partway and
then release it)
The left hand signals will flash 3
times.
To Next Page
Loading...
