41
1-2. Opening, closing and locking the doors
1
Before driving
LX570_OM_OM60L96U_(U)
■ Switching the door unlock function
It is possible to set which doors the entry function unlocks using the wireless remote
control.
Turn the “ENGINE START STOP” switch OFF.
When the indicator on the key surface is turned off, press and hold
for approximately 5 seconds while pressing on the key.
The setting changes each time an operation is performed, as shown below. (When
changing the setting continuously, release the buttons, wait for at least 5 seconds,
and repeat .)
To prevent unintended triggering of the alarm, unlock the doors using the wireless
remote control and open and close a door once after the settings have been
changed. (If a door is not opened within 60 seconds after is pressed, the
doors will be locked again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (P. 121)
STEP 1
STEP 2
STEP 2
Multi-information
display
Unlocking function Beep
Hold the driver’s door handle
to unlock only the driver’s
door.
Exterior: Beeps three
times
Interior: Rings once
Hold either door handle to
unlock all doors.
Exterior: Beeps twice
Interior: Rings once
To Next Page
Loading...
