115
3-2. Opening, closing and locking the doors
3
Operation of each component
NX200t_OM_USA_OM78145U
■ Operation signals
Doors:
A buzzer sounds and the emergency flashers flash to indicate that the doors have been
locked/unlocked. (Locked: Once; Unlocked: Twice)
Windows:
A buzzer sounds to indicate that all windows are opening.
■ Security feature
If a door is not opened within approximately 60 seconds after the vehicle is unlocked, the
security feature automatically locks the vehicle again.
■ Welcome light illumination control
The side marker, parking, tail and license plate lights automatically turn on at night when
the doors are unlocked using the entry function or wireless remote control if the light
switch is in the “AUTO” position.
■ When the door cannot be locked by the lock sensor on the surface of the door handle
■ Door lock buzzer
If an attempt to lock the doors is made when a door is not fully closed, a buzzer sounds
continuously for 5 seconds. Fully close the door to stop the buzzer, and lock the vehicle
once more.
■ Setting the alarm
Locking the doors will set the alarm system. (→P. 77)
■ If the smart access system with push-button start or the wireless remote control does
not operate properly
● Use the mechanical key to lock and unlock the doors. (→P. 597)
● Replace the key battery with a new one if it is depleted. (→P. 540)
When the door can not be locked even if the
lock sensor on the surface of the door handle is
touched by a finger, touch the lock sensor with
the palm.
When gloves are being worn, remove the
gloves.
To Next Page
Loading...
Need help?
General
