239
4-5. Using the driving support systems
4
Driving
NX200t_OM_USA_OM78145U
■ Dynamic radar cruise control can be set when
● The shift lever is in D.
● Vehicle speed is above approximately 30 mph (50 km/h).
■ Accelerating after setting the vehicle speed
The vehicle can accelerate by operating the accelerator pedal. After accelerating, the
set speed resumes. However, during vehicle-to-vehicle distance control mode, the vehi-
cle speed may decrease below the set speed in order to maintain the distance to the pre-
ceding vehicle.
■ Automatic cancelation of vehicle-to-vehicle distance control mode
Vehicle-to-vehicle distance control mode is automatically canceled in the following situ-
ations:
● VSC is activated.
● TRAC is activated for a period of time.
● When the VSC or TRAC system is turned off by pressing the VSC OFF switch.
● The sensor cannot detect properly because it is obstructed in some way.
● Pre-collision braking is activated.
When vehicle-to-vehicle distance control mode is automatically canceled in the follow-
ing situations, “Radar Cruise Control Unavailable” will be displayed on the multi-infor-
mation display:
● Actual vehicle speed falls below approximately 25 mph (40 km/h).
● The windshield wipers are operating at high speed (when the wiper switch is set to the
“AUTO” mode or the high speed wiper operation position).
If vehicle-to-vehicle distance control mode is automatically canceled for any other rea-
son, there may be a malfunction in the system. Contact your Lexus dealer.
■ Automatic cancelation of constant speed control mode
Constant speed control mode is automatically canceled in the following situations:
● Actual vehicle speed is more than approximately 10 mph (16 km/h) below the set vehi-
cle speed.
● Actual vehicle speed falls below approximately 25 mph (40 km/h).
● VSC is activated.
● TRAC is activated for a period of time.
● When the VSC or TRAC system is turned off by pressing the VSC OFF switch.
● Pre-collision braking is activated.
To Next Page
Loading...
Need help?
General
