95
2. Instrument cluster
2
Instrument cluster
NX200t_OM_USA_OM78145U
■ Suspension of the settings display
In the following situations, the settings display using the meter control switches will be
suspended.
● When a warning message appears on the multi-information display
● When the vehicle begins to move
■ Tire inflation pressure
● It may take a few minutes to display the tire inflation pressure after the engine switch is
turned to IGNITION ON mode. It may also take a few minutes to display the tire infla-
tion pressure after inflation pressure has been adjusted.
● “---” may be displayed if the tire information cannot be determined due to unfavorable
radio wave conditions.
● Tire inflation pressure changes with temperature. The displayed values may also be dif-
ferent from the values measured using a tire pressure gauge.
■ When disconnecting and reconnecting battery terminals
The drive information will be reset.
■ Liquid crystal display
→P. 89
■ Cautions during setting up the display
As the engine needs to be operating during setting up the display, ensure that the vehi-
cle is parked in a place with adequate ventilation. In a closed area such as a garage,
exhaust gases including harmful carbon monoxide (CO) may collect and enter the
vehicle. This may lead to death or a serious health hazard.
■ The multi-information display at low temperatures
Allow the interior of the vehicle to warm up before using the liquid crystal information
display. At extremely low temperatures, the information display monitor may respond
slowly, and display changes may be delayed.
■ During setting up the display
To prevent battery discharge, ensure that the engine is operating while setting up the
display features.
To Next Page
Loading...
Need help?
General
