■ How to read oil container label
The International Lubricant Specification Advi-
sory Committee (ILSAC) Certification Mark is
added to some oil containers to help you select
the oil you should use.
Oil viscosity (0W-20 is explained here as an
example):
● The 0W in 0W-20 indicates the characteristic of the oil which allows cold
startability.
Oils with a lower value before the W allow for easier starting of the engine in
cold weather.
●
The 20 in 0W-20 indicates the viscosity characteristic of the oil when the oil is
at high temperature.
An oil with a higher viscosity (one with a higher value) may be better suited if the
vehicle is operated at high speeds, or under extreme load conditions.
Lubrication system (NX250)
■ Oil capacity (Drain and refill) (Reference)
*2
With filter
4.8 qt. (4.5 L, 4.0 Imp.qt.)
Without filter 4.4 qt. (4.2 L, 3.7 Imp.qt.)
"Toyota Genuine Motor Oil" is used in your Lexus vehicle. Use Lexus approved
"Toyota Genuine Motor Oil" or equivalent to satisfy the following grade and
viscosity.
Oil grade: ILSAC GF-6B multigrade engine oil
Recommended viscosity: SAE 0W-16
A
Outside temperature
*2 :
The engine oil capacity is a reference quantity to be used when changing the engine
oil. Warm up and turn off the engine, wait more than 5 minutes, and check the oil level
on the dipstick.
10-1. Specifications
680
To Next Page
Loading...
